ASTM D5019测试标准

ASTM D5019是用于单层屋顶薄膜的增强CSM板(氯磺化聚乙烯)的标准规范：

本规范规定了拟用于单层屋顶薄膜的、用氯磺化聚乙烯(CSM)制造的增强非硫化聚合物板空气曝露测试程序。

ASTM D5019英文简介

1. Scope

1.1 This specification covers reinforced non-vulcanized polymeric sheet made from chlorosulfonated polyethylene (CSM) and poly-isobutylene (PIB) intended for use as a single-ply roof membrane exposed to the weather. The sheet shall be reinforced with fiber or fabric.

1.1.1 The polymers used in these sheets have thermoplastic characteristics at time of installation. The chlorosulfonated polyethylene will vulcanize in place under ambient conditions on a roof.

1.2 The tests and property limits used to characterize these sheets are minimum values specific for each classification.

1.2.1 In-place roof systems design criteria such as fire resistance, field seaming strength, impact/puncture resistance, material compatibility, and uplift resistance, among others, are factors that must be considered, but are beyond the scope of this specification.

1.3 The following precautionary caveat pertains to the test methods portion only, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents

ASTM Standards

D412 Test Methods for Vulcanized Rubber and Thermoplastic Elastomers--Tension

D413 Test Methods for Rubber Property--Adhesion to Flexible Substrate

D471 Test Method for Rubber Property--Effect of Liquids

D518 Test Method for Rubber Deterioration--Surface Cracking

D751 Test Methods for Coated Fabrics

D1004 Test Method for Tear Resistance (Graves Tear) of Plastic Film and Sheeting

D1149 Test Methods for Rubber Deterioration--Cracking in an Ozone Controlled Environment

D1204 Test Method for Linear Dimensional Changes of Nonrigid Thermoplastic Sheeting or Film at Elevated Temperature

D2136 Test Method for Coated Fabrics--Low-Temperature Bend Test

G151 Practice for Exposing Nonmetallic Materials in Accelerated Test Devices that Use Laboratory Light Sources

G155 Practice for Operating Xenon Arc Light Apparatus for Exposure of Non-Metallic Materials